-It is a comprehensive 6-24V DC test kit.
-Its long cable makes your testing easily.
-It allows you to track and locate short circuits.
-It can also test for continuity with the assistance of its auxiliary ground lead.
-The unit has short-circuit protection and can test for bad ground contacts instantly.
current to the tip by rocking the power switch forward or backward.
–Overload Protection —Buzzer Warning.The test pen has overload power-off protection. If the current is too large or the load
is too heavv during the power distribution process.the test pen will be disconnected to protect the battery and a beep warning.
compulsory certification (CCC).
Item Type: Electrical Testers & Test Leads
/ Short Circuit Following and Locating / Checking Short Circuit
continuity is present,the LED will light GREEN. If LED does not light up, no continuity present.
active the component.If LED turns to GREEN with buzzer sounding, stop testing and check the component if defective
or not, or rating current of component is higher than that of this tester.
have LED light RED. Contact probe tip to the positive terminal of component.The component will be activated.
test lead by leave the red clip disconnected from the battery.
is a good tool to test their grounding.
negative terminal of component as dose as possible, LED indicator turns to GREEN with buzzer sounding, which means it
is well grounded. If NOT, the LED remains RED without any buzzer.
contact wire. If LED lights GREEN with buzzer, short circuit or overloading component appears in this side. Please note this
wire’ s color or identification code. Follow the wire as far as you can alonc the wiring harness. Locate the color-coded wire in
the harness and expose it. Cut the wire. Follow the wire in the shorted direction and repeat this process until the short is located.
If there are components in the following wire, check the components individually if good or not.
1. Do not use on AC voltage.
2. Don’t use it if it is damaged.
3. Don’t use this item when driving.
4. Before driving, please always make sure that the vehicle is safe and reliable.
7. Never touch any dangerous part of the vehicle with your hand for safety. Don’t touch any live conductor with hand or skin.
conducted directly to the tip which may cause sparks when contacting ground or certain circuits.
part or subsystem of the electrical circuit.
these components, don’t use the item to apply voltage directly or indirectly.